Turn the ignition on.
Reset sliding door on pontiac van.
A common problem on uplanders is the sliding door roller fails.
Here is how to fix it.
Press the open button on the remote key fob to open the sliding doors.
Open the door as far as it will go.
There could be more than one general motors van with a failing power sliding door others may find that.
Any help recommendaitons would be greatly appreciated.
Move the power sliding door switch to off then move it back to on this switch is located to the left of the steering wheel.
Once the third cycle completes the power door battery is reset.
While looking at the lower track where the door assembly rolls start to close the door about 2 inches or so.
The power sliding door fuse will have to be removed for 1 min.
If the power sliding door or power tailgate doesn t work properly after above procedure have the system checked by an authorized kia dealer.
Push this down easily done with just your finger.
Any time i press the key fob you can still hear this sound from the sliding door.
Open the door with the remote a third time.
The first step is to get a hold of some silicone spray like this stuff for example.
The door will have to be relearned.
Close the sliding door completely using the transmitter or main control button on the overhead console.
Open and close the power sliding doors twice with the overhead or b pillar switch to relearn the position.
Do not grease the rollers as the grease will pick up all foreign matter and will cause more problems with the door.
For the left right power sliding doors and power tailgate follow above steps to reset.
There was a time when the doors stop locking with the key fob.
Sliding door on 2001 pontiac montana.
When i turn off the car and take the keys out of the ignition there is a loud irritating noise from the right sliding door on the passenger side.
The procedure shown here is on a 2006 toyota sienna but the ideas and techniques should apply to most van sliding doors.
Open the sliding door and locate the bearing near the bottom.
If the door reverses and or stops prior to completing the two cycles the procedure will need to be repeated.
Make sure the power sliding door overhead switch is off.