Power Door Lock Not Working On 2008 Dodge Ram

It runs off a 5 volt reference.

Power door lock not working on 2008 dodge ram.

All the switches on all four doors will not work either. My power windows on a 2008 dodge ram 1500 will not close. Could be the issue or the relay it self is bad. Posted on sep 25 2008.

Windows can still work but locks will all stop. I took the wire harness out and tested it and it works fine. Check the driver side door switch control if that goes bad all the locks will stop working including for the key fob. Power door locks do not work.

The 2008 dodge ram 1500 has 1 problems reported for power door lock stopped working. The most recently reported issues are listed below. Symptom summary the power door locks are all inoperative or a single door lock is inoperative. 21 people found this helpful.

The switch provides power to the door lock solenoids. The reason the locks dont work more then likely there is a code stored in the bcm for a lock output circuit normally caused by one if not both of the sliding door acuators. The rear window still opens though. Usual cause the power door locks utilize individual solenoids in each of the doors that activate the door lock mechanism.

Dodge ram 1500 owners have reported 2 problems related to power door locks not working under the electrical system category. The most recently reported issues are listed below. Even if you change the acuators the locks still will not work until the code is cleared. What a forked up way to build stuff.

For a 10 relay gotta spend 500 1000 dollars to fix power door locks.