A pocket door is simply a sliding door that slides back into the wall cavity when opened.
Pocket door behind shower wall.
Another option would be a barn door where the hardware is mounted to the wall above the door and the door slides along the face of the wall and opening.
The other side of the pocket required the plywood pieces to be attached to the drywall before it was screwed to the pocket door wall studs.
There s a 1 4 of plywood over the pocket door frame and the wall framing and then the substrate we re using the wedi system.
Obviously this leaves no room for your needed plumbing lines.
A pocket door slides between the wall layers and the door is installed when the wall is framed.
Since the pocket door wall studs were normally 3 4 inch deep the 1 2 inch plywood never had a chance of touching the moving door.
The tile hasn t been installed yet but the door frame still moves.
It only took a few minutes of extra time to do this.
The 36 side without the plumbing is over a 24 pocket door.
The existing bathroom door swung to the right as you.
Today i am installing a pocket door frame in an existing wall that happens to be for our guest bathroom.
Standard pocket door frames are made to be installed within an interior 2 by 4 wall and therefore they are just wide enough to accommodate the door and a half inch of sheet rock on both sides of the frame.
They used to be very popular in wealthy houses from the end of the nineteenth century to the mid twentieth century.